How to change your Daniel Wellington strap
How to change your Daniel Wellington strap
All of our watch straps are interchangeable and can be easily swapped to change the look of your watch. Our carefully selected assortment of straps allows you to change the style of your watch depending on occasion, mood and personal preference. Follow our step by step instructions or watch in the videos below.
1. Find the tool
1. Find the tool
2. Loosen the spring bar
2. Loosen the spring bar
3. Remove the strap
3. Remove the strap
4. Push in the spring bar
4. Push in the spring bar
5. Attach the new strap
5. Attach the new strap
Step 1: Find the tool

Use the strap tool included in the bottom of your watch case for changing both leather and mesh straps. You can also use a similar, small item with a narrow point (like an earring or a needle) to change or adjust the size of your strap.

Step 2: Loosen the spring bar

Use the narrow end of the tool to push the spring bar through the hole from the side of the lug. When pushed, the spring bar will loosen from the hole and can easily be detached from the other lug.

Step 3: Remove the strap

Detach the strap from the watch and remove the spring bar from inside the strap. The same bar will be used to attach the new strap.

Step 4: Push the spring bar inside the lug

To attach a leather or a mesh strap, push the spring bar through the hole in the watch strap until both ends are visible.

Step 5: Attach the new strap

Place one end of the spring bar in the hole in one lug and push the other end into the hole in the second lug to attach the strap.

To attach a NATO strap, follow the instructions below
1. Attach the spring bar
1. Attach the spring bar
2. Prepare the new strap
2. Prepare the new strap
3. Position the NATO strap
3. Position the NATO strap
4. Slide the strap through the loop
4. Slide the strap through the loop
Step 1: Attach the spring bar to the case

Place one end of the spring bar in the hole in one lug and push the other end into the hole in the second lug.

Step 2: Prepare the new strap

Prepare the new strap by separating the two strap-parts from each other. Pull the longer strap piece up through the metal loop.

Step 3: Position the watch case on the new strap

Start at the top of the watch case and insert the long part of the strap from the front of the watch to the back through the opening between the watch case and the spring bar. Pull the strap and insert it from back to front through the opening at the bottom of the case. Slide the case to the middle of the strap.

Step 4: Slide the strap through the loop

Insert the long end of the strap through the metallic loop at the end of the shorter part of the strap.

Or check our instructional videos


Do you need to adjust the size of your mesh strap?


Do you need to adjust the size of your mesh strap?
© 2019 Daniel Wellington AB